Q Meter

by
q meter

A Q meter measures the quality factor of a circuit Q, which expresses how much energy is dissipated per cycle in a non-ideal reactive circuit. A Q meter is used to measure the Q factor of a coil and related electrical properties.

Q meter tesla bm 500

Q meter

Q meteris based on the principle that Q factor of a resonant circuit is equal to its voltage magnification factor and can be expressed as the ratio of voltage developed across its reactive elements to the voltage injected in series with the circuit to produce the developed voltage.

Q meter

Join EEE Made Easy Telegram channel

Quality factor (Q factor)

The quality factor (Q) of a coil is the ratio of reactance to resistance in a frequency dependent circuit configuration.


The Q factor or quality factor of an inductance is commonly expressed as the ratio of its series reactance to its series resistance.

For inductor in series or parallel, the ratio of reactance to resistance in a frequency dependent
circuit configuration is given by

q meter equation

The value of Q varies from 5 to 1000.


The Q factor of a capacitance is the ratio of its series reactance to its series resistance, lthough for capacitors, generally dissipation factor (D) is used which is the reciprocal of Q.

For capacitor in parallel or series, the ratio of reactance to resistance in a frequency dependent
circuit configuration is given by,

ratio of reactance to resistance

The value of D varies from 10-4 to 0.1

The basic circuit for a Q-meter is shown in Figure below.

Schematic diagram for Q-meter.


The circuit contains terminals for connecting the inductance (Lx ) to be measured and this is brought in resonance by a variable tuning capacitor (C).

There are terminals available for adding capacitance (Cx), if required.


When an unknown coil is connected to the test terminals, the circuit is excited by a tunable signal source.


This is achieved by setting the oscillator to a given frequency and varying the internal capacitor (C) or adding a capacitor Cx of the desired value and adjusting the frequency of the oscillator.

This leads to development of voltage across a resistor in series with the tuned circuit.


The resistance of the resistor should be very small (fractional in ohms) so that it can be neglected in comparison to the loss resistance of the components to be measured.


The AC injection voltage (V in) across the series resistor and the AC output voltage (V
out ) across the terminals of the tuning capacitor are measured using voltmeters.

The circuit for output measurement must be a high input impedance circuit so that loading of the tuned circuit by the metering circuit is prevented.


The Q-factor is measured by adjusting the source frequency and/or the tuning capacitor for a peak output voltage corresponding to resonance.

Q-factor is determined as the ratio of output voltage measured across the tuned circuit to voltage injected into it.

When Lx and Cx are at resonance:

Q = Vout/ Vin

The voltage across the variable capacitor is measured with electronic voltmeter V2 , in which the scale is calibrated to read Q directly.

Join EEE Made Easy Whatsapp Channel

Latest Posts in EEE Made Easy

Latest Posts in EEE Made Easy

Leave a Comment